FOLLOW THE INSTRUCTIONS BELOW FOR BEST RESULTS:
- PREP: Treat in smaller sections of approximately 20 square feet (sq ft) at a time. Example: Floor area of 10 ft x 10 ft = 100 sq ft. Divide 100 sq ft by 20 = 5 sections of 20 sq ft. You would divide your entire floor area into 5 sections and treat one section at a time.
- STEP 1: Clean and rinse entire area to be treated thoroughly.
- STEP 2: Apply SLIP FREE FLOOR™ liberally onto surface & spread over using a sponge or sponge mop.
- STEP 3: Leave on the surface using the recommended processing times in the chart below for each surface type. Surface should remain wet (coated by SLIP FREE FLOOR™ during entire processing time.)
- STEP 4: After processing time is complete, use a clean, wet sponge or sponge mop to thoroughly wash over the treated area to remove any product residue. Rinse mop or sponge continuously in a bucket of water when removing residual product (do not rinse in tub, sink, or toilet). All residual product must be removed immediately after processing time is complete. Once residual product is removed, area is immediately ready for use. SLIP FREE FLOOR™ is not a coating; residual product must be removed.
- NEXT: AFTER TREATMENT CARE: Clean normally with any cleaner. DO NOT WAX. Wax reduces the SLIP FREE capabilities of SLIP FREE FLOOR™. REAPPLY every 6 months for best results.